Q:
How to validate on the Aruba controller if a USB Beacon is connected to an AP-22X?
Use the below command:-
"show ap debug usb ap-name <Name-of-AP>"
If the USB Beacon is connected we would see the below output
(Controller) #show ap debug usb ap-name <Name-of-AP> USB Information --------------- Parameter Value --------- ----- Manufacturer Texas Product TI Serial Number 53556544727953397953 Driver cdc_acm Vendor ID 0451 Product ID 16aa USB Modem State Standby (Controller) #
However, if no USB Beacon is connected to the AP, we would see the below output:-
(Controller) #show ap debug usb ap-name <Name-of-AP> USB Information --------------- Parameter Value --------- ----- USB Modem State Not Plugged (Controller) #
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.