hiho,
I ran into to problem that one of my 24 ap-103 has lost its lan connectivity.
It does have Link and the eth led is on on the iap.
Console says that the lan is active and has correct ip (static, no dhcp).
Console says tthe routing table is fine (all net routes correct default route correct).
I also checked the vlan setup on the switch port the ap is connected to.
Ap is in iap mode and used to connect to our vc.
To me it looks as if everything on the ap is correct and fine but no traffic at all goes through the Ethernet interface.
This hapend all aof a sudden after it worked fine for years (installed in 2014, worked since then).
I even connected it to the switch directly so house wiring is not relevant now since it does the same here (switch is capable of POE btw).
Does anyone have some advice?