Hi it sounds perfect to me,
I am builing this setup in our firm, as soon as i got outside i will try them.
But today ,while i was looking for the qality settings i noticed something else
Our aim in configuring mesh topology is, to connect 2 different buildings,with the mesh link.On each building there will be a switch and some computers that has to reach to the other site,
But in my lab environment, i see that the MeshPoint AP , boots up,and the ethernet port of that AP is down on the remote switch.
when i connect to the wireless network on the remote site, i can succesfully ping the both aps and the other pc, but if i connect with to the lan with my laptop, i cannot ping the Mesh Point AP ,
when i looked to the remote site switch, the MeshPointAp 's port is shutdown state
while mesh setup, i had chosen the MeshPortal Ap as bridge on the eth0 ,if i dont select it like that ,then mesh doesnot work
am i missing something?