Controllerless Networks

Occasional Contributor II

Adding remote branch IAP clusters to Airwave

I'm just getting started with Airwave.  I have about 50 remote sites with IAP clusters.  I have two common SSIDs (Employee and Guest) which are common between each site.  I also have a unique WPA-PSK SSID at each site for RF scanners.  I am currently adding each site as their own group in Airwave and enabling Instant Config within Airwave.  Is this the right way to go about this?  If I wanted to do a mass change across all of the remote site VCs (i.e. changing the admin password) would this be possible with my setup?  Should I have used templates instead?

Guru Elite

Re: Adding remote branch IAP clusters to Airwave

You can do groups for common configurations. If most of your sites have a common configuration with only a few differences at each site, you can use a single group and utilize the VC override options in the Instant Config UI


| Tim Cappalli | Aruba Security | @timcappalli | |

NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Occasional Contributor II

Re: Adding remote branch IAP clusters to Airwave



Thanks for your quick response.  This is exactly what I was looking for.

Re: Adding remote branch IAP clusters to Airwave

Further to what Tim has said, I think you should have different groups for different countries.

If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACCX #817, ACMP, ACMX #294
Search Airheads
Showing results for 
Search instead for 
Did you mean: