Hello All,
I am desperate for some help. I have 14 AP's on a L3 Network.
AP IP Addresses:
192.168.5.101 to 192.168.5.114 (Mac Address reservations on Windows SBS 2003 server).
VC Address 192.168.5.100
SSIDS:
Staff - VLAN 10 - 192.168.5.0/24
VIP - VLAN 20 - 192.168.4.0/24
Guest - VLAN 60 - 192.168.6.0/24
Entertainment - VLAN 30 192.168.7.0/24
All SSID's setup with static VLAN thats controlled by L3 switch and all SSID's are set as an employee network with WPA2 Personal.
Now the AP's were visable before by going to the web interface, I did an automatic firmware upgrade to 6.3.1.2-4.0.0.4_42384
This was completed successfully, of so it seemed. The AP's were previously on 6.2.1.0-3.3.0.3_39227
Now since a reboot of my POE switch I cannot get to the VC or any individual IAP-105. I cannot even ping them?! However they are all working, all LED's green and WiFi SSID's displayed in all areas, can connect and go on internet etc.
The only way I can get to the VC/IAP-105 is to unplug them al and plug them in one at a time, if you plug in any more than one then thats it you cannot see them! I did notice that out of my 14 IAP-105's only 2 of them are actually on 6.3.1.2-4.0.0.4_42384 firmware and the rest are on 6.2.1.0-3.3.0.3_39227 firmware.
But if I try to auto upgrade the ones still on 6.2.1.0-3.3.0.3_39227 it fails with unexpected error or with time out!
Please someone help!! Although the WiFi network is working its not possible to manage/monitor it.
Regards,
Rob.