Controllerless Networks

Reply
Highlighted
Occasional Contributor I

Can I use Virtual Controller ip as Radius client address?

Hi

I have set up an Instant AP as a Virtual Controller, and given the Controller a static ip. I then set up an SSID with 801.1x auth, using one of our DCs as a Radius server.

This is all working, except that the Auth request originates from the ip address of the AP, not the address of the Virtual controller.

This suggests that I will have to set up a Client on the Radius server for each AP.

Is there a way of using one Radius Client address for the whole Wireless network?

 

Many Thanks

Adrian


Accepted Solutions
Highlighted
MVP Expert

Re: Can I use Virtual Controller ip as Radius client address?

Please enable Dynamic Radius Proxy , under System so it can use the VC IP address
Thank you

Victor Fabian
Lead Mobility Architect @WEI
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA

View solution in original post


All Replies
Highlighted
MVP Expert

Re: Can I use Virtual Controller ip as Radius client address?

Please enable Dynamic Radius Proxy , under System so it can use the VC IP address
Thank you

Victor Fabian
Lead Mobility Architect @WEI
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA

View solution in original post

Highlighted
Moderator

Re: Can I use Virtual Controller ip as Radius client address?

Enable Dynamic RADIUS proxy. (DRP)


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

Highlighted
Occasional Contributor I

Re: Can I use Virtual Controller ip as Radius client address?

Thanks Victor and Tim, I had played with that in the SSID, but not enabled it under System. All working now, many thanks for the quick responses.

Adrian

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: