Controllerless Networks

Occasional Contributor II

Debug IAP-CAP conversion progess in AP side



Is there any debug or show command on Aruba Instant OS to check how the conversion progess go, is it finished successfully or not?


We find that sometimes you do it properly, but in many cases, nothing happens after the release of the convert-aos-ap command in the cluster, even if you type it several times with a few minutes difference.


Sometimes it happens to start the reboot (one would think the conversion was done) but it will come back with Instant software as well.


IAP cli shown this:

xx:xx:xx:xx:xx:xx# convert-aos-ap cap x.x.x.x
Converting to Controller based AP. Will automatically reboot when done.


We access only the AP side, not the controller.


Any advice for AP side debugging to see what happening?



Guru Elite

Re: Debug IAP-CAP conversion progess in AP side

show log upgrade

show log system

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide
Occasional Contributor II

Re: Debug IAP-CAP conversion progess in AP side

Thanks, I will try it and reply.


Re: Debug IAP-CAP conversion progess in AP side

Search Airheads
Showing results for 
Search instead for 
Did you mean: