Controllerless Networks

Reply
Contributor I

Re: High CPU on mesh portal IAP 175

It is possible to disable DFS in instant mode? 

Super Contributor I

Re: High CPU on mesh portal IAP 175

You can change the allowed channels arm can use by do the following in the CLI:

 

(Instant AP)(config)# arm
(Instant AP)(ARM)# a-channels <channel-list>
(Instant AP)(ARM)# end
(Instant AP)# commit apply

 

http://community.arubanetworks.com/aruba/attachments/aruba/IAP/6226/1/Aruba%20Instant%206.4.0.2-4.1%20CLI%20Reference%20Guide.pdf

ACDX #419 | ACMP |
Super Contributor I

Re: High CPU on mesh portal IAP 175

You can also do it in the GUI (had to get into my instant demo to take a look). If you go to RF -> Show Advanced Options and select Customize Valid Channels under Access Point control then you can edit the allowed channels. See attached image.

ACDX #419 | ACMP |
Contributor I

Re: High CPU on mesh portal IAP 175

Thanks a lot! In logs there was problem with channel 100+. I changed allowed channel from 36-64. Unfortunately this is global settings (in fact I could set it only on particular AP) - I will monitor behaviour the whole WLAN from radio point and I hope it will be work. 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: