Controllerless Networks

Reply
Highlighted
Occasional Contributor II

How configure IAP103 in bridge mode ?

Hello,

 

I want to configure my IAP 103 in Bridge mode, do you know what's process can I follow?

I have a first IAP who broadcast signal and I want configure the second IAP in bridge mode.

 

I understand, I have to configure an eth0 Bridging on the second IAP who is in bridge mode, but I don't know what configuration I have to make on the first IAP who broadcast signal.

 

Thank you in advance for your help.

 

Best regards,

Chabin972


Accepted Solutions
Highlighted
Moderator

Re: How configure IAP103 in bridge mode ?

IAP's operate in bridge mode out of the box. All traffic except NAT'd guest, some management and traffic destined for a tunnel is switched out locally at the AP.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post


All Replies
Highlighted
Moderator

Re: How configure IAP103 in bridge mode ?

IAP's operate in bridge mode out of the box. All traffic except NAT'd guest, some management and traffic destined for a tunnel is switched out locally at the AP.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: