Controllerless Networks

Reply
Highlighted
Contributor I

How to upgrade an IAP 115 using the cli

How do I upgrade system firmware using the CLI?


Accepted Solutions

Re: How to upgrade an IAP 115 using the cli

Upgrading an Image Using CLI

 

To upgrade an image using a HTTP, TFTP, or FTP URL:

(Instant Access Point)# upgrade-image <ftp/tftp/http-URL>

 

To upgrade an image without rebooting the IAP:

(Instant Access Point)# upgrade-image2-no-reboot <ftp/tftp/http-URL>

 

To view the upgrade information:

(Instant Access Point)# show upgrade info

 

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos

View solution in original post


All Replies

Re: How to upgrade an IAP 115 using the cli

Upgrading an Image Using CLI

 

To upgrade an image using a HTTP, TFTP, or FTP URL:

(Instant Access Point)# upgrade-image <ftp/tftp/http-URL>

 

To upgrade an image without rebooting the IAP:

(Instant Access Point)# upgrade-image2-no-reboot <ftp/tftp/http-URL>

 

To view the upgrade information:

(Instant Access Point)# show upgrade info

 

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos

View solution in original post

Highlighted
Contributor I

Re: How to upgrade an IAP 115 using the cli

Thanks Seth - this worked great!  Tftp was taking too long so I installed an Apache http server and it was able to upgrade pretty quickly after that.  The Internet connection at this location is not very good and it would fail to upgrade when using the GUI.

Highlighted
New Contributor

Re: How to upgrade an IAP 115 using the cli

 Can i use the same commands for an ap225? I'm adding an ap225 to a virtual controller (ap135). 

Highlighted
Guru Elite

Re: How to upgrade an IAP 115 using the cli

Yes.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Aruba Central Documentation
ArubaOS Consolidated Release Notes
Aruba VIA ASE Solution - Configure VIA VPN
Highlighted
Occasional Contributor II

Re: How to upgrade an IAP 115 using the cli

Will the cmd work in apboot mode on a IAP 105? If not, how to upgrade if no DHCP server and not joining to cluster?

Highlighted
Contributor II

Re: How to upgrade an IAP 115 using the cli

Are we able to upgrade the ap image from the cli using the console commands (purgeenv and saveenv level)?