Controllerless Networks

Reply
Highlighted
Super Contributor II

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

I had seen some issues in the past with the IAP VPN when placing users in the same VLAN as 'normal' CAP users. After separating the CAP and IAP users the issues was fixed. Could you try this?
The users only appear in the user table if they will have an IP address.
Because the user is also not in the bridge table there is an issue with the datapath.

Willem Bargeman ACMX#935 | ACCX #822

Please give me kudos if my post was useful!
If your issue is solved mark the post as solution!
Contributor I

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

 I tried a different VLAN (one that is used for RAP wired connections). Still no change. 

Contributor I

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

Looking over things, I'm wondering if the issue is related to the routing profile. I have it set to 0.0.0.0/0.0.0.0 with a next hop of the controller's IP for the VPN. Is this correct? I'm not quite seeing in the document how to set the route for all traffic to go over the tunnel.

Super Contributor II

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

A routing profile is not needed because it’s a L2 iap VPN.

Could you share a tech support from the IAP and controller? You can send me a PM

Willem Bargeman ACMX#935 | ACCX #822

Please give me kudos if my post was useful!
If your issue is solved mark the post as solution!
Occasional Contributor I

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

Hi,

 

Do you have some news, I've got the same problem too :( 

Aruba Employee

Re: IAP IPSEC VPN L2 Centralized - Unable to get DHCP

make sure you are using Aruba IPsec as the VPN protocol,

Also check the routing profile settings in this technote.

 

https://community.arubanetworks.com/t5/Controllerless-Networks/IAP-VPN-Centralised-L2-and-Distributed-L3-with-3G-4G-pre-emption/td-p/528954

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: