Hello Fello Airheads!
I have a RAP-108 that doesnt seem to want to be an IAP. I believe that this has the ability to be an IAP but it wont load. Ive tried many different versions of iap software and all have the following output.
apboot>
apboot> upgrade os 192.168.10.79:ArubaInstant_Pegasus_6.4.2.0-4.1.1.0_46028
eth0 up: 100 Mb/s full duplex
DHCP broadcast 1
DHCP IP address: 192.168.10.100
DHCP subnet mask: 255.255.255.0
DHCP def gateway: 192.168.10.1
DHCP DNS server: 192.168.10.1
DHCP DNS domain:
Using eth0 device
TFTP from server 192.168.10.79; our IP address is 192.168.10.100
Filename 'ArubaInstant_Pegasus_6.4.2.0-4.1.1.0_46028'.
Load address: 0x2000000
Loading: #################################################################
#################################################################
#
done
Bytes transferred = 8562652 (82a7dc hex)
Invalid machine type in image: 0x1a
**** ERROR: upgrade failed ****.
apboot>
the device is definitely a RAP-108 also:
APBoot 1.2.7.14 (build 34663)
Built: 2012-07-28 at 11:47:31
Model: RAP-108/RAP-109
CPU: AR9344 revision: 1.2
Clock: 560 MHz, DDR rate: 450 MHz, Bus clock: 225 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 32 MB
Power: 802.3at POE
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0033 00002 01 00000004 00000000 00000000 00000000
Net: eth0
Radio: ar9590#0, ar9344#1
I can however get the device to boot as a CAP/RAP with the mips32.ari image.
Ive tried factory resetting it and all of that but it just never turns into an instant. Any input would be greatly appreciated.
Thanks!
#AP225