02-22-2017 02:42 AM - edited 02-22-2017 10:13 AM
Im facing a little problem.
I try to get the 2540 into our aruba central account.
Things that i did:
show activate provision Configuration and Status - Activate Provision Service Activate Provision Service : Enabled Activate Server Address : device.arubanetworks.com Activation Key : Not Available
The activation key is not shown. This is a indication that it cannot reach aruba activate?
# aruba-central enable # show aruba-central Configuration and Status - Aruba Central Server URL : None Connected : No Mode : NA Last Disconnect Time : NA
The DNS is set and i can ping:
ping device.arubanetworks.com device.arubanetworks.com is alive, time = 146 ms
From this network i also tryed to get a IAP into central. This is no problem and works right away.
I also tryed to add the switches to central using the SN and MAC. I also assigned a subscription key.
I have requested a activate account but it takes a few days to get this account approved.
Tested both with 16.2 and 16.3 firmware.
Someone knows a solution?
Solved! Go to Solution.
Re: Unable to get aruba 2540 switches in aruba central
11-29-2018 12:51 AM
I have had the same issue with my Aruba 2530.
what I worked out eventually was a way to force the switch to reconnect to Aruba Central
I used the following commands:
activate provision enable
activate provision force
This then gave me the activation key
And when I ran the following command
I was presented with
Server URL : https://device-eu.central.arubanetworks.com/ws
Connected : Yes
Mode : Monitor
Last Disconnect Time : NA
Hope this helps.