Attemped to use LACP to configure the ports but I'm unable to get the AP to come up.
I've tried:
active mode and short timeout
active mode and long timeout
passive mode and short timeout
passive mode and long timeout
The AP boots but the 5GHz and 2.4GHz lights stay amber.
The AP doesn't appear to have any network connectivity.
I'm unable to ping it from the switch and vice versa.
-------------
When I set the port channel that the AP is patched into to be STATIC instead of LACP the AP comes up and seems to work. When I configured another STATIC port channel and patched another AP in, I'm getting mixed results. First time the switch became unresponsive till I unpatched the 2nd AP. Second time I tried it the AP just keeps rebooting.... with the following showing up on the console as before....
Completed SW FIPS KAT test
<<<<< Welcome to the Access Point >>>>>
Launching IAP CLI...
[ 27.871029] process `snmpd_sap' is using obsolete setsockopt SO_BSDCOMPAT
[ 49.227780] i am master now
[ 49.261163] (00:00:48) !!! Init ---> Master
[ 49.311221] asap_send_elected_master: sent successfully
User: [ 64.345585] ethernet_device_event: dev eth1 is up
[ 65.580893] OOPS. someone else thinks hes the master too
[ 65.644510] I am MASTER. recv-ed a master normal-beacon.
[ 65.708126] (00:01:05) master provision, 0 vs. 0
[ 65.763371] (00:01:05) Beacon ap-ip, 192.168.222.253 vs. 192.168.222.252
[ 65.843603] (00:01:05) Beacon 3G capability, 0 vs. 0
[ 65.903007] (00:01:05) Beacon ap-class, 25 vs. 25
[ 65.959288] (00:01:05) Beacon uptime, 32763 vs. 1993937
[ 66.021821] (00:01:05) !!! Lose the master election
[ 66.080173] (00:01:05) !!! Master ---> Slave
[ 66.131251] Add bridge entry for magic vlan GW, ifindex 8453, 18:64:72:c5:46:da
[ 66.218782] wait for stm to initialize over
[ 66.268829] asap_send_elected_master: sent successfully
[ 67.732507] PHY: eth1 (mdio@ffe24000:01) - Link is Up - 1000/Full
Sending SIGKILL to all processes.
Please stand by while rebooting the system.
Might log this with TAC... :smileyhappy: