Controllerless Networks


Re: What's the switchport configuration for IAP225's?

Ok it appears that the APs do not respond to the LACP requests from the switch when the IP address on the AP is static.


When the IP is set via DHCP it works fine.


The config I'm using is:


(ArubaS2500-48P) #show interface-profile lacp-profile active-short

LACP "active-short"
Parameter Value
--------- -----
Group identifier 0
Priority 255
Mode active
Timeout short


(ArubaS2500-48P) #show interface-profile switching-profile trunk

switching profile "trunk"
Parameter Value
--------- -----
Switchport mode trunk
Access mode VLAN 1
Trunk mode native VLAN 1
Enable broadcast traffic rate limiting Enabled
Enable multicast traffic rate limiting Disabled
Enable unknown unicast traffic rate limiting Enabled
Max allowed rate limit traffic on port in percentage 50
Trunk mode allowed VLANs 1-4094


(ArubaS2500-48P) #show interface-config port-channel 0

port-channel "0"
Parameter Value
--------- -----
LACP active-short
Interface MSTP Profile default
Interface Rapid PVST Profile default
Interface GVRP Profile N/A
Interface Ethernet Link Profile pc_default
Interface QoS Profile N/A
Interface Policer Profile N/A
Ingress Port Mirroring Profile N/A
Egress Port Mirroring Profile N/A
Interface Shutdown Disabled
Interface MTU 1514
Interface Ingress ACL N/A
Interface Egress ACL N/A
Interface QoS Trust Mode aruba-device
Interface Description N/A
Interface Switching Profile trunk
Interface Security Profile N/A
Static IGMP Multicast Router port for the VLANs 0
Static MLD Multicast Router port for the VLANs 0
HSL backup interface N/A
HSL preemption mode Off
HSL preemption delay 100
Port channel member list N/A


LACP Status on the AP:


AP01-47:0c# show lacp

AP LACP Status
Link Status LACP Rate Num Ports Actor Key Partner Key Partner MAC
----------- --------- --------- --------- ----------- -----------
Up slow 2 17 1 00:1a:1e:09:85:c0
Slave Interface Status
Slave I/f Name Permanent MAC Addr Link Status Member of LAG Link Fail Count
-------------- ------------------ ----------- ------------- ---------------
eth0 18:64:72:c5:47:0c Up Yes 0
eth1 18:64:72:c5:47:0d Up Yes 0
Traffic Sent on Enet Ports
Radio Num Enet 0 Tx Count Enet 1 Tx Count
--------- --------------- ---------------
0 0 0
1 0 0
non-wifi 2 506


Note: The wired setting on the AP ports are set to trunk, native VLAN 1.




ACCX #540 | ACMX #353 | ACDX #216 | AMFX #11

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.

View solution in original post

Search Airheads
Showing results for 
Search instead for 
Did you mean: