I just installed an iAP (or rather had a technician install it) at a remote location, where it obtained an IP address from DHCP and I connected to the GUI.
First step I upgraded the code to 3.4 (it shipped to us on 3.1)
After the reboot, I can't connect on HTTP/S -- It starts to connect and eventually times out.
If I try to connect on port 443 I get redirected to 4343, and then time out.
Is there a way to get it to check in to Airwave from the CLI so I can push a full configuration out to it?
Or a way to fix the GUI?