Forum Français

MVP Guru Elite

Re: Problème déploiement OVF Clearpass

@jeremy.e wrote:

Hi all,


Finally, regarding the 2 NICs, I put them in the same subnet and I'm actually only using the management interface. It's not a clean deployment but I had to fit customer's limitations.


Thanks all for your help.



You don't get error when set ip address on the same subnet for 2 interfaces ? (when you setup ClearPass, data interface is not mandatory)

PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info

PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info

PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)

PowerArubaIAP: Powershell Module to use Aruba Instant AP

PowerArubaMC: Powershell Module to use Mobility Controller / Master

ACMP 6.4 / ACMX #107 / ACCP 6.5 / ACSP
Occasional Contributor I

Re: Problème déploiement OVF Clearpass

You're right, my mistake, I did not configure the Data management interface because I had been prompted with same subnet alert.

Thanks for correcting :).



Search Airheads
Showing results for 
Search instead for 
Did you mean: