Attempted adding Aruba 2930 to AMP using default v2c and it failed the first time. Then, I added SNMP v3 community, user, and enabled SNMPv3 and it failed using those same creds on AMP. Then, I tried the same using SNMPv2c with a community and got the same result. I have tried every combination of using telnet/ssh, community, and user fields and always get an "SNMP get failed".
I was able to add CPPM to AMP just fine though, but not 2930 switches.
I want to start from scratch now.
What specific config on the 2930 needs to be configured? ,,,AND ...
What specific config on AMP needs to be configured on the DEVICE--> ADD page (ssh ? community ? user ?)
NOTE: Using latest version of AMP from Dec-2019 which is 8.2.X
NOTE: Aruba 2930F switch sh version info below:
# sh version
...
Nov 1 2019 19:24:11
WC.16.10.0002
208
Boot Image: Primary
Boot ROM Version: WC.16.01.0008
Active Boot ROM: Primary
#2930F