Network Management

Reply
Highlighted
Occasional Contributor II

Adding HPE Unified WLAN Controller + APs to Airwave 8.2.7.1

Hello together,

 

I'm trying to add two HPE WLAN Controllers to my Airwave installation, including selected Access Points from this infrastructure.

 

The controllers were successfully added via SNMPv2, but I can't see any APs from the HPE Unified infrastructure.

 

When I click "Add Device", I tried to add them as "HPE 10500/7500 Unified Wired-WLAN Switch". I get following output then:

 

amp-wlc.PNG

 

It shows me "APs: 0"

Could someone help me to add the APs (Model MSM 460)?

 

Best regards

Highlighted
MVP Expert

Re: Adding HPE Unified WLAN Controller + APs to Airwave 8.2.7.1

Is it wired switch or WLAN controller? Deafult all the APs will be discovered in new device list.


Pavan Arshewar | ACCP

If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: