Network Management

Reply
Occasional Contributor II

AirWave 8.2.9 and 8.2.10 Virtual Machine Requirement

Hi Experts,

 

I am looking for virtual machine sizing for AirWave. In my network, there are 2xAruba-7030 Controller, 2xClearpas C1000 and 35xAruba AP-345.

Can somebody help me with the virtual machine requirement for the above network?
I have also found many sizing guides and collected some details but I need some document reference or some more clarity to instruct my server team for virtual machine allocation.

VM-Sizing Guide 8.2.9.JPGMy assumptions for the VM requirements are as below
RAM – 8 GB
vCPU – 4
Hard Disk – 250 GB

I'm not an expert on virtual machines and it would be great if you guys can help me with the above.

Thanks in advance.

ryh
Contributor II

Re: AirWave 8.2.9 and 8.2.10 Virtual Machine Requirement

For your relatively small sizing, and without knowing the type of environment this is being deployed in, I would normally scope for somewhere around the following:

 

CPU: 4 vCPU

RAM: 12 GB

HDD: 400 GB

 

The AirWave application likes RAM and all of the resource needs tend to grow over time.  Even with a smaller site as yours appears, 8GB would be resource constrained, and 250GB of disk space could fill up though with some records retention settings may be tweaked to accommodate.  As the guides indicate, if you have a lot of new/unique client devices in your environment then you need to scale upward.  The system performance tab is your friend in evaluating the health of the system - I usually check back in a few months after installation to see if RAM, CPU, HDD is meeting the needs of AW.

 

ClearPass doesn't add to the requirements much, but you will want to take advantage of the Endpoint Context Server function that CPPM and AW can utilize together.  This allows you to jump into AW for the device directly from the Access Tracker within CPPM for a wonderfully seamless troubleshooting workflow.  Here is an older link to this feature: https://community.arubanetworks.com/t5/Security/ClearPass-Tips-and-Tricks-AirWave-Diagnostic-Link/td-p/226319

 

In case you need to upgrade AW to 8.2.10.x, here is a post I made to help explain the process: in short, if upgrading from a previous release you will most likely need to reinstall AW from scratch and copy over an upgraded backup file.

 

Good luck!

Occasional Contributor II

Re: AirWave 8.2.9 and 8.2.10 Virtual Machine Requirement

Thanks ryh,

 

will check on the same.

Highlighted
MVP Guru

Re: AirWave 8.2.9 and 8.2.10 Virtual Machine Requirement

For VM envorinment to montior your current network devices count, below resource needed to be allocated

 

RAM - 16GB

CPU -6  Physical Cores Intel Xenon

Hard disk: 400GB

 

 

Regards,
Pavan
If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Occasional Contributor II

Re: AirWave 8.2.9 and 8.2.10 Virtual Machine Requirement

Thanks for the response

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: