12-31-2018 02:19 AM
Im trying to commision some switches (2930F) based on zero touch provisioning with Airwave and a DHCP server.
The DHCP server is configured to supply the correct Group, folder parameters and ip address. Under AMS Setup > General > Automatic Authorization "Automatically Authorized Switch Mode" is configured for "Manage Read/Write"
But somehow the first switch being added to the group needs some manual intervention.
It shows up under New Devices.
Debug on the switch shows
I 01/01/90 00:03:08 05101 amp-server: AMP server configuration is disabled due to first configuration.
After manualy setting it to Manage Read Write the configuration from my template is being pushed.
Any subsequent switches do get provisoned correctly. No intervention needed.
Is this normal behaviour? Can I make AirWave handle the first switch the same as the other switches?
AirWave version being used is 22.214.171.124
Hope someone can clarify on what's going on.
With kind regards,
Solved! Go to Solution.
12-31-2018 06:41 AM
It is expected behaviour, in ztp first device will be discovered in new device list and we have to acknowledge it manually. From the second ZTP device onwards for the same group and folder as the first device, it will automatically move into the corresponding group and folder.
If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.