Network Management

Occasional Contributor II

Airwave & AP224

I have recently begun an installation of AP224s. In the past when i have installed an ap it automatcially showed up in airwave after 15-20 minutes. (version 7.7.4) The 224s are not showing up. Does anybody have a solution


Re: Airwave & AP224

Try upgrading to 7.7.8.  There were a bug fixes directly related to AP224/225 support in 7.7.8.  If the AP still doesn't show, then please open a support case as support for those models should be available.

Rob Gin
Senior QA Engineer - Network Services
Aruba Networks, a Hewlett Packard Enterprise Company

Re: Airwave & AP224

I agree with Rob but on the off chance you have copied the config from one IAP to another, make sure the "virtual-controller-key" is different across all the VCs as well or else if you have more than 1 VC using the same "key" only 1 will talk back
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: