Hi,
AirWave automates provisioning of several models of HPE OfficeConnect (Comware) switches, using template-based configuration, zero-touch provisioning (ZTP), and configuration snippets. By default, the full configuration mode is enabled whenever you create a device group. When in full configuration mode, AirWave pushes a complete set of changes using a template to the group of devices. With partial configuration mode, you can push a golden configuration to a group that contains factory-default ZTP devices. You can also push any command supported by the switch CLI to the device group regardless of their device state (factory or non-factory).
- We need to make sure, the device configuraiton status is in Good state before we place the device in manage mode.
- Airwave Groups are configuration specific, so make sure add controller/IAP/swtiches which have similar configuration to manage from single group.
- Yes, we need to create two different groups
Regards,
Pavan
If my post addresses your query give kudos:)