Hey Guys,
I have ~100-125 hp 1920 switches where i am trying to add the NTP/DST settings to via airwave. I have set up a config job and pushing out the 3 lines i need and it works great. The issue is that it doesn't save the config, so if the switch reboots i lose my settings. I tried to add the following to the bottom of my config job
save
y
y
This works if i telnet into the switch and run it. It says, y to config the blank for the enter to overwrite the startup.cfg and a y to confirm again. The blank i use for enter doesn't translate well when used in a config job and it doesn't work.
I was able to get around this with a save force. It creates a startup-bak.cfg file as a back up and does successfully save the switch. Is this going to cause any problems or should i proceed with the save force?
I am open to other ways but i was hoping to do it nicely via Airwave.
Thanks for any input.