12-15-2017 07:48 AM
Hello, I'm trying to figure out what the difference is between configuring the ip address of an airwave server on my MM controller, vs. adding the ip of my controller to airwave. If I add the airwave ip to my controller, nothing seems to happen -- airwave doesn't pick it up. But the documentation is unclear about what to put for the snmp community string -- is this the community string on the airwave server that "pushes" data to airwave? Or is it pulled from airwave, and this should be the snmp community configured on the controller? Are there any logs showing what the controller is trying to do when you set the ip of the airwave server?
Solved! Go to Solution.
12-15-2017 07:53 AM
You need to:
1- Set an SNMP read string on the controller
2- Add the Controller in Airwave using Add Device(s)
3-Put the ip address of Airwave in the controller
Step 1 and 2 sets up Airwave to poll the controller via SNMP
Step 3 sets the controller to push a data feed (AMON) to Airwave
Step 3 will not display any data in Airwave until steps 1 and 2 are completed.
*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Learning Videos
Aruba Central Documentation
ArubaOS Consolidated Release Notes
Aruba Technical Webinars