Network Management

Reply
Highlighted
Contributor I

Failed to convert IAP to Remote AP - VPN failed

I hope someone can help me - I need to convert 2 x IAP (207 and a IAP225) to a Remote AP to be controlled by a controller.

 

But during converting - we find that it laways fails during 'setting up VPN' status..

 

We conencted the IAPs directly to the controller on the network, so it can directly connect and find the controller on it's IP. But unfoirtunatley it fails every time during 'setup VPN' ..

 

I have attached the techdump support file form the IAP207. Can anyone have a look ..Thanks

 

 

Highlighted
Guru Elite

Re: Failed to convert IAP to Remote AP - VPN failed

Did you add those access points to the RAP whitelist on the controller?

Did you create a pool of addresses on the controller for those remote APs?


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Video Knowledge Base
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide
Highlighted
MVP Expert

Re: Failed to convert IAP to Remote AP - VPN failed

check the following:
- Did you configure a RAP pool?
- Is the MAC address in the RAP whitelist
- If you have CPsec turned on make sure the MAC address is in the CPSec whitelist



Thank you

Victor Fabian

Pardon typos sent from Mobile
Thank you

Victor Fabian
Lead Mobility Architect @WEI
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: