- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
11-28-2011 01:07 PM
Hello All,
Our first AMP server runs on a DL360 with 2 x 300Gb SAS drives. I configured these within the BIOS for RAID 1 which suits for the time being.
Is there any way of seeing the health/status within Centos of the drives/RAID?
Ideally, I'd like AMP to monitor it's own HDD status and send alerts on a drive or even PSU failure, but I guess that's a lot to ask?!?!
Suggestions gratefully received!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
11-28-2011 01:24 PM
This isn't something that's built into the AirWave application. You'll need to install HP's utilities for monitoring the hardware in your server.
Thse might be some good places to start. You're looking for software for CentOS 5 or Red Hat Enterprise Linux 5 (64-bit):
http://blog.mattbrock.co.uk/2010/01/25/monitoring-diskraid-hardware-in-centos-5-on-hp-dl360-servers/
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: RAID status within Airwave/Centos
11-28-2011 01:31 PM
@The.racking.monkey wrote:Hello All,
Our first AMP server runs on a DL360 with 2 x 300Gb SAS drives. I configured these within the BIOS for RAID 1 which suits for the time being.
Is there any way of seeing the health/status within Centos of the drives/RAID?
Ideally, I'd like AMP to monitor it's own HDD status and send alerts on a drive or even PSU failure, but I guess that's a lot to ask?!?!
Suggestions gratefully received!
No. Since the RAID 1 is via the RAID controller, not the OS, to my knowledge, it will only be visible with a specific piece of software from HP. I believe the Proliant Support pack for CentOS may provide that. However, there is no telling whether or not AMP is compatible with this software. I am not completely familiar with the linux version of Proliant Support pack. It may just enable SNMP gets on the status of the HD.
Zach Jennings
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: RAID status within Airwave/Centos
11-28-2011 11:58 PM
Thanks. Will the Airwave support guys have any issues if I do install that?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: RAID status within Airwave/Centos
11-29-2011 05:04 AM
We support the AirWave application on Red Hat Enterprise Linux installations that are entirely done by customers.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator