Network Management

last person joined: yesterday 

Keep an informative eye on your network with HPE Aruba Networking network management solutions
Back to discussions
Expand all | Collapse all

RF Health Report - SNR in percentage

This thread has been viewed 0 times

  • 1.  RF Health Report - SNR in percentage

    Posted Jun 23, 2015 04:04 AM

    Hi there.


    Looking into the RF Health reports, adjusting the threshholds for SNR is done by percentage. What is the relation between SNR in % and SNR measured in dB? If I want to set the threshhold for triggering "Low Client SNR" in the RF Health report to 20 dB, what is the equivalent in percentage?

     

    Best regards

    J. Mark



  • 2.  RE: RF Health Report - SNR in percentage

    Posted Jun 23, 2015 07:31 AM

    I dont know the percentage relation (im assuming that it might be related to the RSSI but im not sure) 

    But you could change the default threshold value which is 15 in the RF Health report definitions 

    2015-06-23 07_21_36-AMP-SERVER.png



  • 3.  RE: RF Health Report - SNR in percentage

    Posted Jun 24, 2015 03:39 AM

    Hi Victor.

     

    Thank you for your input, that's the exact value I want to adjust. My question however is, if 20% in the report definition corresponds to a 20 dB threshhold that I am running in the rest of my setup. My controllers' dashboards report low SNR below 20 dB as well as the client diagnostics in AirWave, so I want my reports to strictly report the same.

     

    Best regards

    J. Mark.