Network Management

Reply
Occasional Contributor II

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

   hi, any update with this case? the same is happening to me, there is no problem with the 2530F, but with the 5406Zl2 it does not bring information

 

Firmware Software revision  : KB.16.04.0009 

 

thank

Highlighted
Regular Contributor I

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Our local HPE Aruba SE was able to correct this problem by going into the configuration of the 5400-series switches and adding this:

 

snmp-server response-source dst-ip-of-request

 

 

Airwave then polled and the switches showed as 'up'. Why this configuration command is necessary now when it wasn't previously is unknown to me at this point, but it might be worth trying.

Contributor II

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Thank you 

The string "snmp-server response-source dst-ip-of-request" solved my problem.

 

Occasional Contributor II

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Thank you, the problem was solved

Occasional Contributor II

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

This was a lot harder to find than I would have expected. Works perfect now. Thanks. 

Occasional Contributor I

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Hi Sir ,

I'm encountring the ''error in SNMP polling: Timeout(interface monitor) '' would you please help me out to deal with this.

 

Respectfully,

Thanks.

MVP Guru

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Are you seeing this snmp timeout (interface_monitor)  for switches?

 

"Error in snmp polling unknown error (interface monitor)”

 

Do you see any data in Device>Interface page, if not and device is switch then try increase snmp-agent packet max-size to 3500 and check the status

Regards,
Pavan
If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.
Occasional Contributor I

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Would you please explain using screen shots , ?

FYI : my airwave running 8.2.5.1 version.

 

Thanks in advance.

Occasional Contributor II

Re: SNMP get failed error after upgrade from Airwave 8.2.4 to 8.2.5

Hi, in the switch execute , in mode configuration ,

snmp-server response-source dst-ip-of-request

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: