Network Management

Reply
Highlighted
Contributor II

Using Airwave to backup Controllers

Hi,

 

I see that starting in Airwave 8 is possible to use airwave to backup Controllers configuration. But I cannot found how to do this on our envirolment. 

 

On User Guide I did not find any example on how to configure this feature. Someone has an exemple?

 

We use Airwave as "Monitor" not for configuration change. 

 

 

Regards,

Paulo Raponi


Accepted Solutions
Highlighted
Moderator

Re: Using Airwave to backup Controllers

In the group settings where your controller lives, be sure "Audit configuration" is enabled.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post


All Replies
Highlighted
Moderator

Re: Using Airwave to backup Controllers

As long as you have SSH credentials defined, it will automatically backup the controllers. You will see the backups under Audit.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

Highlighted
Contributor II

Re: Using Airwave to backup Controllers

I do not find the audit tab...

 

Can you help me with this?

Highlighted
Moderator

Re: Using Airwave to backup Controllers

When you click on a controller, there will be a sub menu at the top that says Audit.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

Highlighted
Contributor II

Re: Using Airwave to backup Controllers

I did not find the menu ... My user are Admin...

We use Airwave as monitor. Not config change...

 

aruba-audit.png

Highlighted
Moderator

Re: Using Airwave to backup Controllers

In the group settings where your controller lives, be sure "Audit configuration" is enabled.


Thanks,
Tim


If this response is more than 1 year old, it may no longer be accurate. Please consult official Aruba documentation, TAC or your Aruba SE.

| Aruba Alumni | @timcappalli | timcappalli.me |

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: