Reply
Highlighted
Frequent Contributor I

IPSec UP (Tunnels) does not show

Hi All,

We are using 3.3.2.18-rn-3.1.3.
When we connect RAP-2/5 and even AP61 as RAP, the IPSec UP columns do not show the numbers of RAP devices.
Is it normal?
The SSIDs are running split tunnel. (There's some typo errors on the user guides on split tunnel)

Michael

Which firmware version can we use?
Highlighted
Guru Elite

IPSec Tunnels


Hi All,

We are using 3.3.2.18-rn-3.1.3.
When we connect RAP-2/5 and even AP61 as RAP, the IPSec UP columns do not show the numbers of RAP devices.
Is it normal?
The SSIDs are running split tunnel. (There's some typo errors on the user guides on split tunnel)

Michael

Which firmware version can we use?




The Monitoring Screen should reflect a 1 for every RAP device that is currently connected to the controller. If not, please upgrade to the latest code and check it again. The latest code is in 3.3.2.24-rn-3.1.8.

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.5 User Guide
InstantOS 8.5 User Guide
Airheads Knowledgebase
Airheads Video Knowledge Base
Remote Access Point Solution Guide
ArubaOS Consolidated Release Notes
ArubaOS 8 ViA VPN Solution Guide
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: