Frequent Contributor I show user-table output

In previous versions, when using the "show user-table" to determine the mac address of a client connected directly to a RAP port, it would either show authenticated or denied, depending on whether the MAC Address was added to the WLAN controller internal DB. RAP AAA profile is configured with the default-mac-auth profile. Came across a situtaion where on, the show user-table output doesn't show the client if in a denied state, but will show if in a authenticated state. Had to use the show ap wired stats to obtain the MAC Address.

Guru Elite

Re: show user-table output



Did the client get an ip address?  If it did not, that could be why it is not in the user table.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Airheads Learning Videos
Frequent Contributor I

Re: show user-table output

It did not, but in the past (when on code 6.1.x.x) I believe I recall that it would show up in the user-table without an IP Address with role "denied".


Re: show user-table output

nope, that must have been the station table..

No ip, no entry in the user-table. 

Koen (ACMX #351 | ACDX #547 | ACCP)

-- Found something helpful, important, or cool? Click the Kudos Star in a post.
-- Problem Solved? Click "Accept as Solution" in a post.
Search Airheads
Showing results for 
Search instead for 
Did you mean: