Auto populating SNMP read credentials
10-02-2019 06:29 AM
Is there any way to set up a default snmp V3 set of credentials so when adding a new device the SNMP v3 setup gets populated automagically ?
Cuts down on device regustration time !
Re: Auto populating SNMP read credentials
10-02-2019 07:17 PM
We can configure commuication details in Device Setup > Communication > Default Credentails
When ever you try add the device it automatically take this credentails.
Pavan Arshewar | ACCP
If my post address your queries, give kudos and accept as solution!
NOTE: Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba or Hewlett Packard Enterprise.