UnknownAutzParams - Juniper / Trapeze CoA

[SwissARUBA]

Hi Everyone,

I am trying to send a CoA request to a Juniper (Trapeze) WLC 880R. 

I am getting the following errors in the logs from the Enforcement Policy.

DEBUG Core.PETaskRadiusCoAEnfProfileBuilder - Adding attr=Radius:IETF:NAS-IP-Address|value=%{Application:WebLoginURL:portal_ip} to the EnforcementProfile outlist
DEBUG Core.PETaskRadiusCoAEnfProfileBuilder - Adding attr=Radius:IETF:Calling-Station-Id|value=%{Connection:Client-Mac-Address-Colon} to the EnforcementProfile outlist
DEBUG Core.PETaskRadiusCoAEnfProfileBuilder - Adding attr=Radius:IETF:Filter-Id|value=ClusterPermitALL.in to the EnforcementProfile outlist
DEBUG Core.PETaskRadiusCoAEnfProfileBuilder - Adding attr=Radius:Trapeze:Trapeze-CoA-Username|value=%{Authentication:Username} to the EnforcementProfile outlist
DEBUG Core.PETaskRadiusCoAEnfProfileBuilder - buildParamsToFetch: Building parameters to fetch for RadiusCoAEnforcement
INFO Core.PETaskRadiusCoAEnfProfileBuilder - UnknownAutzParams to fetch for RadiusCoAEnfProfiles: :
INFO Core.PETaskRadiusCoAEnfProfileBuilder - UnknownNAutzParams to fetch for RadiusCoAEnfProfiles: :

I can see no payload even arriving at the Receving WLC. 

Any Ideas?

Thanks,

Jaggie

CP 6.6

[Victor Fabian]

Try this and see if it works:

[SwissARUBA]

Hi Victor,

I added the the Framed IP Addrress as this was the only thing that was different in my policy to your screenshot.

I am assuming that the order doesn't make any difference?

Thanks,

Jaggie

[Victor Fabian]

No

Sent from Outlook for iPhone

[SwissARUBA]

Unfortunately I have the exact same error.

Thanks,

John

[Victor Fabian]

Do you have accounting enabled on the trapeze WLC ?

Sent from Outlook for iPhone

[SwissARUBA]

Nope accounting is not enabled but I have added the CP server as a DAC server on the WLC.

I have other DAC servers that can make CoA requests to these WLCs and accounting is not enabled for them either.

Thanks,

Jaggie

[Victor Fabian]

I ran into an issue with CoA and trapeze when accounting was enabled.

Also how do you have the trapeze WLC identified as under network devices ?

Sent from Outlook for iPhone

[SwissARUBA]

Accounting is enabed on CP but not on the Juniper WLC. 

CP is doing accounting for an Aruba Mobility Controller.

The device is declared as "Trapeze" but I have also tried to swap this to "Juniper" with the same error.

Thanks,

Jaggie

[Victor Fabian]

Please change it to IETF as vendor name