Wired Intelligent Edge (Campus Switching and Routing)

Reply
New Contributor

2930F + AP303 + Controller 7005 / Multi SSID VLAN Setup

Hello,

 

I´m currently setting up a new network for a customer, which would like to have 4 SSIDs, each with a different VLAN and normal WPA2 login.

(I know, there are other ways, but the customer want´s it exactly like that).

 

This is the current setup:

Switch 2 - 2930F (IP Address 192.168.63.22):

Default Gateway: 192.168.55.1 (VLAN 55),

Router with IP 192.168.55.1 on Port 24 (Default VLAN 1)

Switch 3 on port 50

AP 1 on Port 13 (VLAN 63 untagged, Port IP Address 192.168.63.22)

Default VLAN 1 IP Address: 192.168.55.47

 

Switch 3 - 2930F (IP Address 192.168.63.23):

Default Gateway: 192.168.52.22

Switch 2 on Port 50

AP 2 on Port 39 (VLAN 63 untagged, Port IP Address 192.168.63.23)

Controller on Port 40 (VLAN 63 untagged)

 

Controller 7005:

IP: 192.168.63.201

Port 0/0/0 admin state enabled (link to switch 3) all other disabled

Management VLAN 63

 

Router config as it was told to me from out ISP:

Master:
address 192.168.55.2/24
virtual-address 192.168.55.1/24
    vif 48 {
        address 192.168.48.2/24
            virtual-address 192.168.48.1/24
    vif 49 {
        address 192.168.49.2/24
            virtual-address 192.168.49.1/24
 

Long story short:

A workmate started this project, now its my. I started with about 90% of the actuall configuration (changed a port and some little things) and i never worked with aruba components before.

All 4 WLANs with different VLANs must get access to the internet.

I have searched on google (where i found this community) and set the trunk port on the controller.

On the switches, the vlans are tagged, and at this point i don´t know where the mistake is.

I have added some pictures from the config sites (yes I am a gui fan ;) ), had to blur some parts, because of the company name.

 

2930_2.png2930_3.png7005_1.png7005_2.png7005_3.png7005_4.png7005_5.png

MVP Expert

Re: 2930F + AP303 + Controller 7005 / Multi SSID VLAN Setup

Do you have a schema ?

 

do you want to use rouing feature of 2930F ?




PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info


PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info


PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)


PowerArubaIAP: Powershell Module to use Aruba Instant AP




ACMP 6.4 / ACMX #107 / ACCP 6.5
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: