Hi,
i want to use my 2930F as OSPF Routers instead of L2 Switches. So i configured OSPF area backbone and on all ports that belong to the routing process. The UL-Ports are tagged vlans because the 2930f can not have L3 Ports and in the vlans the ospf ptp statement is configured with /30 Mask. Everything fine so far BUT i got two routed uplinks so ECMP should happen but in my routing table is every Subnet not twice, just once. The neigbour is the same switch in this case. Currently my routes from the living LAN are all from type external2 because of using mpls and redistribution into bgp but this should not impact ecmp ? Normally i want to see every route twice because i have two links with same speed and conditions ?!
Thanks for suggestions!
Config Snippets:
router ospf
area backbone
redistribute connected
redistribute static
enable
exit
vlan 110
name "transfer"
tagged 3/49
ip address 10.20.120.37 255.255.255.252
ip ospf 10.20.120.37 area backbone
ip ospf 10.20.120.37 network-type point-to-point
jumbo
exit
# sh ip route
as you can see the above vlan 110 snippet is not used in here only the vlan 109 takes place in the table.
IP Route Entries
Destination Gateway VLAN Type Sub-Type Metric Dist.
------------------ --------------- ---- --------- ---------- ---------- -----
0.0.0.0/0 10.127.127.34 109 ospf External2 10 110
10.1.0.0/16 10.127.127.34 109 ospf External2 10 110
10.2.0.0/22 10.127.127.34 109 ospf External2 10 110
10.3.4.0/22 10.127.127.34 109 ospf External2 10 110
in "other" vendor configs there is a max-path command under the OSPF but this is not in the ArubaOS.
#2930F