Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Aruba Employee

2nd DHCP scope on 2930f

The following is the running config, where i defined two DHCP scopes on my 8P 2930f.

 

VLAN 1 works fine and provides client IP's, however VLAN 20 wont provide any client IP's on ports assigned 1-2

"
vlan 1
name "DEFAULT_VLAN"
no untagged 1-2
untagged 3-10
ip address 192.168.8.10 255.255.255.0
dhcp-server
exit


vlan 10
name "VLAN10"
tagged 3-6,8-10
ip address 10.10.10.10 255.255.255.0
exit


vlan 20
name "VLAN20"
untagged 1-2
ip address 172.16.20.10 255.255.255.0
dhcp-server
exit


management-vlan 1
dhcp-server pool "IAP"
default-router "172.16.20.10"
dns-server "8.8.8.8"
network 172.16.20.0 255.255.255.0
exit


dhcp-server pool "lab"
default-router "192.168.8.1"
dns-server "8.8.8.8"
network 192.168.8.0 255.255.255.0
range 192.168.8.50 192.168.8.200
exit


dhcp-server enable

"


Accepted Solutions
Highlighted
Aruba Employee

Re: 2nd DHCP scope on 2930f

Range was missing on VLA 20, though it was not mandatory and the scope will just start at .1

 

Its working fine now

View solution in original post


All Replies
Highlighted
Aruba Employee

Re: 2nd DHCP scope on 2930f

Range was missing on VLA 20, though it was not mandatory and the scope will just start at .1

 

Its working fine now

View solution in original post

Highlighted
MVP Guru

Re: 2nd DHCP scope on 2930f

It's good to have a look here too.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: