Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Occasional Contributor I

5412zl2 and QSFP into Blade Center

Hi

 

I've had this open for a while on the HP forum;

 

https://community.hpe.com/t5/Aruba-ProVision-based/QSFP-Configuration-to-Synergy-12000/m-p/7035966#.XHZKnS2cZTb

 

No one's answered, so I thought I'd try my luck here? 

 

Anyone?

 

Pete (PeteNetLive)


Accepted Solutions
Highlighted
Occasional Contributor I

Re: 5412zl2 and QSFP into Blade Center

Problem solved the -  'sub' oe 'virtual' interfaces on the Synery needed adding to the uplink group

 

See

HPe Synergy 12000 MPIO QSFP to 10GB SFP Setup

 

 

Pete

View solution in original post


All Replies
Highlighted
MVP Guru

Re: 5412zl2 and QSFP into Blade Center

"for a while" is not the case...you just wrote it on Monday February 25th...two days ago!

 

Are you sure you don't need to configure LACP on ports on the Synergy side? it seems like first port of each QSFP going to separate Switch (Slot 3 and Slot 6) - Synergy side - is unblocked and remaining ports are blocked...are both Switches - Synergy side - deployed as an IRF (so they appear as a logical Switch to the Aruba 5400R zl2) in order to use a LACP with links spanning to both Synergy Switches (Slot 3 and 6)?

Highlighted
Occasional Contributor I

Re: 5412zl2 and QSFP into Blade Center

Hi - Yeah Sorry, I'm in forums a lot, Usually on the answering side at Cisco and Experts Exchange, 2 days is a long time for me !

 

Anyway, to answer, LACP IS setup on the Synergy it configures it by default when you create an 'uplink group', with no interaction. The latest firmware (which I put on last week, let's you change the LACP load balancing algorythm, but its on 'select based on  source ip and mac, and destination ip and mac' anyway.

 

Pete

Highlighted
Occasional Contributor I

Re: 5412zl2 and QSFP into Blade Center

Update: Got a call open with the Aruba support team, they tell me they can not see any misconfiguration on the 5412.

 

They are contacting the Synergy team to see if this is default behaviour

 

 

Regards

 

Pete (PeteNetLive)

Highlighted
Occasional Contributor I

Re: 5412zl2 and QSFP into Blade Center

Problem solved the -  'sub' oe 'virtual' interfaces on the Synery needed adding to the uplink group

 

See

HPe Synergy 12000 MPIO QSFP to 10GB SFP Setup

 

 

Pete

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: