2 weeks ago
I have a customer with 2530 Switches and MSM430 Access-Points- We are using 802.1x with EAP-TLS, PEAP and MAC Authentication.
The APs do not tunnel the client traffic to the wifi controller.
I have configured the APs to authenticate over PEAP what is working fine.
But clients are connected to wife on a access-point do not get a network connection because of the local breakout to the network.
Device Profiles are not working with MSM Access-Points. How can I do authentication the Switch-Ports with a connected access-point?
This is the Port-Config
aaa port-access authenticator 1
aaa port-access authenticator 1 client-limit 1
aaa port-access supplicant 1
aaa port-access mac-based 1
aaa port-access mac-based 1 unauth-vid 6
Solved! Go to Solution.
Re: 802.1x Auth on Switch-Port with Access-Points
2 weeks ago
You need to push device mode
PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)
PowerArubaIAP: Powershell Module to use Aruba Instant AP
PowerArubaMC: Powershell Module to use Mobility Controller / Master
ACMP 6.4 / ACMX #107 / ACCP 6.5 / ACSP