Wired Intelligent Edge

Hello,

Does anyone know when the 8320’s will support an ACL being applied to a VLAN interface?

Alternatively does anyone know another way to achieve this on a VLAN ... on an interface wont work for what I’m trying to do.

Thanks

The 8320 switch support extended ACL and in that VLAN ACL(VLAN-ACL) as well.

 

for configuring the VLAN based ACL find the below configuration template.

 

1) configure the extended ACL name

SW(config)# ip access list  extended < name>

2) configure the rules that permit the traffic or deny the traffic like

SW( config-ext-NaCl) # permit udp any host 10.x.x.x eq boots

 

apply the ACL inbound to vlanxx

SW(config)# VLAN xx IP access-group name in

 

Aruba is providing the one advanced switching course ( Implementing the campus switching) 

 

https://certification-learning.hpe.com/tr/datacard/Course/01095999

 

 

Is there anything related to arubaos-cx training on the inter-tube similar to the excellent cisco based cbt-micro-nuggets for arubaos-cx ????

It is supported since release 10.2.

Thanks ... I’m running version

TL 10.02.0010

I don’t see the support for those commands on this ArubaOS-CX?

Went into the conf mode ... vlan 100 - everything else after the vlan 100 doesn’t allow further options?

Tried going into the vlan interface to apply a access list but no options there either?

Thanks

you need to enter "apply access-list ip|ipv6|mac name in" in the vlan

(not the L3 vlan interface).

Perfect - thanks