Wired Intelligent Edge (Campus Switching and Routing)

Reply
Contributor II

AOS-CX: boot / reload / restart / disconnect TIMER ?

I perform remote AOS-CX maintenance on a regular basis.

 

There are times my revised/new settings may cause my remote discussion to be disconnected.  The LARGE changes at time then do not allow me to reconnect to the AOS-CX switch.  I would like a system similar to the AOS-switch (hpe provision) where one can time a reload.  If one sets the reload timer to reload, and the time code is met, the switch is rebooted w/ saving the config and then the new settings are dropped.

 

Is this type of "auto boot" available on AOS-CX???  Have not found in aos-cx manuals or on airheads.

 

-N

 

-----
# Thanks # Gracias # Merci # ありがとう # Danke # Spasiba # 감사합니다 # Toda # Cheers # Dhanyawaad # Ahsante # Xièxiè # shukran #

 

 

Highlighted
MVP Expert

Re: AOS-CX: boot / reload / restart/ disconnect TIMER ?

Do you have look checkpoint ?

 

and also do you have look the tool NetEdit ?




PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info


PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info


PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)


PowerArubaIAP: Powershell Module to use Aruba Instant AP




ACMP 6.4 / ACMX #107 / ACCP 6.5
Contributor II

Re: AOS-CX: boot / reload / restart / disconnect TIMER ?


@alagoutte wrote:

Do you have look checkpoint ?

 

and also do you have look the tool NetEdit ?


Thanks alagoutee !!!   (and a shout-out to parnassus for similar help in a related POST).

 

From 8320 (10.03) CLI DOC:

 

Syntax
checkpoint auto <TIME-LAPSE-INTERVAL>


Description
Starts the auto checkpoint mode. In auto checkpoint mode, the system temporarily saves the runtime
configuration as a checkpoint only for the specified time lapse interval.

 

Usage
To save the runtime checkpoint permanently, run the checkpoint auto confirm command during the
time lapse value set by the checkpoint auto <TIME-LAPSE-INTERVAL> command. The filename for the
saved checkpoint has the AUTO<YYYYMMDDHHMMSS> syntax. If the checkpoint auto confirm command is
not entered during the specified time lapse interval, the previous runtime configuration is restored.

 

 

*****BEGIN: ACTUAL TESTED CLI CHECKPOINT EXAMPLE BELOW *****

                    (minimally edited for POST presentation clarity)

 

HPE-AOSCX8320-DO-NOT-REVISE# check auto 2

 

Auto checkpoint mode expires in 2 minute(s)

 

WARNING Please "checkpoint auto confirm" within 2 minutes

 

HPE-AOSCX8320-DO-NOT-REVISE# conf

HPE-AOSCX8320-DO-NOT-REVISE(config)# hostname what-me-worry

 

what-me-worry(config)# exit

 

WARNING: Restoring configuration. Do NOT add any new configuration.

Configuration changes will take time to process, please be patient.

Restoration successful

 

HPE-AOSCX8320-DO-NOT-REVISE#

 

 

                    (minimally edited for POST presentation clarity)

*****END: ACTUAL TESTED CLI CHECKPOINT EXAMPLE ABOVE *****

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: