Wired Intelligent Edge

last person joined: 16 hours ago 

Bring performance and reliability to your network with the HPE Aruba Networking Core, Aggregation, and Access layer switches. Discuss the latest features and functionality of your switching devices, and find ways to improve security across your network to bring together a mobile-first solution
Back to discussions
Expand all | Collapse all

AP port config for Cisco switches

This thread has been viewed 4 times

  • 1.  AP port config for Cisco switches

    Posted Aug 14, 2012 01:53 PM

    When hooking up an Aruba Access Point to a cisco switch what port configurations should be set on the cisco switch?



  • 2.  RE: AP port config for Cisco switches

    Posted Aug 14, 2012 01:57 PM

    802.3af Power Over Ethernet (PoE) = enabled :)

     

    Other than that...  if the Aruba AP is in tunnel mode, then the switchport should be in standard access mode with a single VLAN.

     

    If the Aruba AP is in bridge mode, then the switchport should be in standard trunk mode, with multiple VLANs corresponding to the networks to be bridged.