Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
New Contributor

AirWave Switch Template // 2930F not showing variables

AirWave: 8.2.9.0

2930F: WC.16.09.001

 

I have a group "switch" that has a template within it that has variables that are within the pre-defined list on the AMP template page. 

 

When I add the switch to the group (initially monitor mode) then change it to read/write -- I am not seeing the variables as options to fill out for the switch...at all under the "manage switch" section.

 

Thoughts?

Highlighted
Occasional Contributor I

Re: AirWave Switch Template // 2930F not showing variables

I have the same issue on new group and config pulled from the only switch in the group.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: