Hi!
We have couple of Vendor Class Id = HP J9775A 2530-48G Switch and they can connected with each other via LAG LACP.
Some times when I am typing command on the CLI then it process the command really slow and if I check the cpu usage then I see something like below and if 1 sec ave is above 30 percent then its always slow while typing the command and if its below 30 or some low value then its fine.
23 percent busy, from 2 sec ago
1 sec ave: 37 percent busy
5 sec ave: 14 percent busy
1 min ave: 5 percent busy
I have seen this save behaviour in one of our remote office on just one Aruba 2530 24 port switch and on that location we have 3 more 2530-48G but didnt see this issue there.
I also have few 2530-48G on another remote location but they dont have this issue.
I am not sure what it can be? Can it be some old broken cable connected to it or something else?
Can you suggest how can I trouble shooth this?
Thanks