Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
New Contributor

Aruba 2540 Fan Speed Issue

Hi,

 

I have just inboxed 6 brand new Aruba 2540 switches to configure for one of our customers however I am having an issue with one of the switches in which the fans are constantly at max speed (Same speed as when they are booting), I was on the phone to HP for an hour earlier as the 'heartbeat' LED was flashing at the same time the fans were at full speed. We managed to fix the flashing LED by changing the firmware however the fan issue is still there.. 

 

Does anyone have an ideas why and how I can fix it without RMA'ing the switch?

 

Thank you!

Occasional Contributor II

Re: Aruba 2540 Fan Speed Issue

Hi,

 

Seems an hardware issue to me. The temperature sensor or the fan controller might be defective. Don't think you can fix this in software.

MVP Expert

Re: Aruba 2540 Fan Speed Issue

Can you report the output of the show system fan command?

 

It should show you something similar to:

 

aruba2540-jl355a# show system fans

Fan Information
  Num  | State       | Failures | Location 
-------+-------------+----------+----------
Fan-1  | Fan OK      |   0      | Chassis 

0 / 1 Fans in Failure State
0 / 1 Fans have been in Failure State

Thanks.

 

 

New Contributor

Re: Aruba 2540 Fan Speed Issue

UPDATE: The switch was sent back to HP and a replacement was sent out. Thanks for the helpful comments!

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: