Aruba switch per port tunneled node
07-02-2020 05:03 AM
I have an aruba controller 7205 and an aruba 2540 switch.
I want to configure per port tunneled node on the switch, it seems like that this feature is not allowed on the aruba 2540 switches.
Which aruba switches support this feature and in which softwareversion?
Re: Aruba switch per port tunneled node
07-02-2020 05:53 AM - edited 07-02-2020 05:54 AM
You will need a 2920/40 or one of the higher end model switches with os 16.04 or higher.
Also some key points to note:
*Make sure the tunneled node vlan Is present on both the switch and the controller.(Also check the status of the vlan)
*Check to see if Jumbo frames are enabled.
*Make sure you have sufficient licenses for each PPTN.
ACMA (V8) | ACMP (V8) | CCENT | CCNA (R&S) | PAN-OS 8.0 ACE