02-16-2019 02:16 AM
I am currently going through the process of upgrading our office LAN using Aruba 8320 as the core switches using VSX and Active Gateways, however I was wondering if you can configure a secondary Active Gateway on the same VLAN?
I have tried to look through the configuration commands but it I cannot find any obvious options and if I try to add another active gateway with different IP address and MAC it just overwriters the original, I have also looked online but there does not seem to be a lot of documentation at the moment.
Ideally I would like to seperate these IP ranges onto different VLANs or assign a new larger subnet to the VLAN but for various reasons this is not possible.
I am currently running version 10.01.0048, please let me know if you need more information.
Solved! Go to Solution.
Re: ArubaOS-CX Secondary Active Gateways
02-18-2019 12:57 AM
I not sure if it is possible...
to have try to add a secondary active gateway with another MAC address ?
PowerArubaSW: Powershell Module to use Aruba Switch API for Vlan, VlanPorts, LACP, LLDP... More info
PowerArubaCP: Powershell Module to use ClearPass API (create NAD, Guest...) More info
PowerArubaCX: Powershell Module to use ArubaCX API (get interface/vlan/ports info)
PowerArubaIAP: Powershell Module to use Aruba Instant AP
ACMP 6.4 / ACMX #107 / ACCP 6.5
02-18-2019 03:47 AM
according to "ArubaOS-CX Virtual Switching Extension (VSX) Guide for 10.02", Chapter 3 VSX, subchapter "Active gateway over VSX":
- Only one IPv4 and IPv6 active gateway can be configured on an SVI.
So I think, you're out of luck...
Please Accept as solution, if my post was helpful.