Wired Intelligent Edge (Campus Switching and Routing)

Reply
Occasional Contributor II

Auto configuration upon Aruba AP detection - 2540

Hi All, 


Does anyone have a list of the elements of auto config that are supported by the 2540? The feature was release in FW16.01 which i think was before 2540 so it isnt mentioned like others that dont support certain elements like egress rate limit. 

Aruba Employee

Re: Auto configuration upon Aruba AP detection - 2540

Greetings!

 

Here are the specific parameters you can configure as part of a device profile (including the default AP profile) on the 2540:

 

 allow-jumbo-frames    Configure jumbo frame support 
for the device port. cos Configure the Class of Service (CoS)
priority for traffic from the device. egress-bandwidth Configure egress maximum bandwidth
for the device port. ingress-bandwidth Configure ingress maximum bandwidth
for the device port. poe-max-power Configure the maximum PoE power for
the device port. poe-priority Configure the PoE priority for the
device port. speed-duplex Configure the speed and duplex for the
device port. tagged-vlan Configure this port as a tagged member
of the specified VLANs. untagged-vlan Configure this port as an untagged
member of specified VLAN.


MATTHEW FERN
TECHNICAL MARKETING ENGINEER, WIRED INTELLIGENT EDGE

Aruba, a Hewlett Packard Enterprise company

8000 FOOTHILLS BLVD  |  ROSEVILLE, CA 95747
T: 916.540.1759  |  E: mfern@hpe.com
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: