Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted
Frequent Contributor II

Configuration migration from 5406zl to 5406zl2

Hello All, 

I'm planning to replace 5406zl  with the new Aruba 5406zl2, 

to migrate the configuration the existing configuration I'm thinking about something easy like copy/past running configuration from old zl to the new zl2 ... is that right ? 

 

is there any guide/recommendations/best practice for that? 

 

 


Accepted Solutions
MVP Expert

Re: Configuration migration from 5406zl to 5406zl2

The configuration is almost the same. If you are going to use VSF you need to update the port numbers.
But if the port numbering is almost the same copy/past should work. Depends also on the complexity of the configuration

Willem Bargeman ACMX#935 | ACCX #822

Please give me kudos if my post was useful!
If your issue is solved mark the post as solution!

View solution in original post


All Replies
MVP Expert

Re: Configuration migration from 5406zl to 5406zl2

The configuration is almost the same. If you are going to use VSF you need to update the port numbers.
But if the port numbering is almost the same copy/past should work. Depends also on the complexity of the configuration

Willem Bargeman ACMX#935 | ACCX #822

Please give me kudos if my post was useful!
If your issue is solved mark the post as solution!

View solution in original post

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: