Wired Intelligent Edge (Campus Switching and Routing)

Reply
Highlighted

Configuring controller IP (on the controller)

Hi, I have a controller where I would like to change self IP or controller IP for tunneled node service. Currently it shows like this:

 

#show tunneled-node-mgr stat

IP address
----------------
self_ip: 10.133.5.61.
controller ipv4: 10.133.5.61.

I'd like to change this to another IP address/VLAN. If I try to connect switches to the other IP they fail with 

 

TNT mtnodeUserCtrl:Switch Bootstrap Failed, Req sent to non controller or non cluster IP : 10.133.9.61

APs connect to 10.133.9.61 fine, but I can't create dynamic segmentation stuff.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: